Metrohm IC Net 2.2 - Manual (Page 55)

5.4 Metrohm PC Board
IC Net 2.2 47
Read current parameters from 771
Compact Interface.
Send current parameters to 771 Compact
Interface.
Links
The Links tab of the 771 IC Interface is used for COM port selection
and settings (details see section 5.2.4 Links).
5.4 Metrohm PC Board
The 2.714.0310 Metrohm PC Board Interface is a two channel
Analog-to-Digital Converter (often abbreviated as ADC) to ac-
quire two analog signals from two different detectors simultane-
ously or time independent (e.g. conductivity detection and UV de-
tection).
One or two PC Boards can be installed in the same PC: PC
Board 1 is the first interface, PC Board 2 is the second interface
installed in the PC. They differ in different jumper settings on the
board. The «IC Net» program is the successor for the former «IC
Metrodata for Windows» program used to work with the PC
Boards.
The 6.2128.140 cable is used to connect the analog output of the
732 IC Detector (or another detector) and the contact closure
output of the 733 IC Separation Center to the Metrohm PC Board.
The Metrohm PC Board must be installed with the new system
wizard or by using the
option of the Workplace win-
dow (see section 5.1.2). However, there is no PC Board icon on
the toolbar after installation. The PC Board can only be seen in
the
Workplace window opened with Options / Devices setup . By
double-clicking the MeBoard1 or MeBoard2 item, the MeBoard# win-
dow opens with the following tabs:
Device settings Manual control and startup values for PC
Board (it is recommended not to change
any of these parameters!).
Links Window for COM port selection and set-
tings (it is recommended not to change any
of these parameters!).
For detailed information about the Metrohm PC Board see on-line
help and Instructions for Use for «IC Metrodata for Win-
dows».