Metrohm IC Net 2.2 - Manual (Page 87)

6.5 817 Bioscan
IC Net 2.2 79
Full scale The full scale range (operating range) sets
the desired sensitivity for the analog output.
The possible values of the full scale range
depend on the preset measuring
Range .
Offset Offset of the zero point for the analog out-
put signal.
Selection:
-50 ... +50 % (in steps of 10 %)
Actual
E1, E2 Display of current start and end potentials
in V.
Scan cycle Display of current scan cycle mode.
Scan rate Display of current scan rate in mV/s.
Oven Display of current oven state.
Range Display of current measuring range.
Full scale Display of current full scale range.
Offset Display of current offset.
Send current parameters immediately to the
817 Bioscan. Parameters are not stored in
the system file (
*.smt ) as long as the file is
not saved.