Metrohm 763 PVC Thermomat Manual User Manual
Page 87
4 Operation
763 PVC Thermomat
80
Sort and filter determinations
763 PVC THERMOMAT RESULTS / Determination / Sort / Ascending
Sorts the records in the determination overview according to the field
contents in the selected column (marked column or column in which
the cursor is located) in increasing sequence. If several columns are
marked then the records will be sorted beginning with the first marked
column from the left. The sorting conditions are stored under
Special fil-
ter/sorting
.
763 PVC THERMOMAT RESULTS / Determination / Sort / Descending
Sorts the records in the determination overview according to the field
contents in the selected column (marked column or column in which
the cursor is located) in decreasing sequence. If several columns are
marked then the records will be sorted beginning with the first marked
column from the left. The sorting conditions are stored under
Special fil-
ter/sorting
.
The ascending or descending sort can be removed again by clicking
on
or
Determination / Filter / Remove filter/sorting
. If the sort is not
removed then it is retained until a new sorting process is carried out.
If sorting has been switched off it can be used again by clicking on
or
Determination / Filter / Apply filter/sorting
.
For complex sorting processes with several columns a
Special sorting
must be used.
763 PVC THERMOMAT RESULTS / Determination / Filter / Selection based filter
The selection-based filter is a method for filtering records rapidly and
conveniently. This is done by first marking a part of an entry or the
complete entry in a field in the determination overview. After activating
the selection-based filter the table is filtered so that only records which
contain the marked entry are shown. The filtering conditions are stored
under
Special filter/sorting
.
The filter can be removed again by clicking on
or
Determination /
Filter / Remove filter/sorting
. If the filter is not removed then it is retained
until a new filtering process is carried out.
If filtering has been switched off it can be used again by clicking on
or
Determination / Filter / Apply filter/sorting
.
For complex filters a
Special filter
must be used.