Metrohm 763 PVC Thermomat Manual - Manual (Page 23)

2 Installation
763 PVC Thermomat
16
2.4.3 Basic settings
When the program is started for the first time several basic settings
must be made for the 763 PVC Thermomat. Proceed as follows:
1 Switch on instruments
• Check if the PVC Thermomat has been connected correctly to
the PC (see section 2.4.1).
• Switch on the PVC Thermomat using mains switch 12 12.
• Switch on the PC.
2 Start program and login
• Double-click the software icon to start the program. The
program window with the opening picture is opened and the
Login window appears on the screen:
•
Do not enter any password here, just click on
word> . The following window appears:
•
Leave the
Old password
field empty. Under
New password
enter
the required password which will in future allow you to log in
as Administrator . Confirm the new password by renewed entry
in the Confirm new password field and click on .
• Enter the new
Password
again in the
Login
window. You are
now logged in as Administrator .
• Confirm the message There are no units configured yet with
. The
763 PVC THERMOMAT CONTROL
window appears.