Metrohm 763 PVC Thermomat Manual - Manual (Page 26)

3.1 Determinations
763 PVC Thermomat
19
3 Operating tutorial
This section introduces you to the operation of the 763 PVC Thermo-
mat by means of a brief operating tutorial which describes the basic
operating steps needed for performing determinations and display of
results.
For further explanations of the operation, please refer to section 4.
3.1 Determinations
The determination of induction and stability time of a PVC sample at
200 °C and a gas flow of 7 L/h is used an illustrative example. Please
note that the steps and parameter settings described apply only to
this example. If you use a different sample and different parameters,
the procedures described in the tutorial must be modified appropri-
ately.
3.1.1 Installation
Before you start this brief tutorial, the 763 PVC Thermomat must be
correctly installed as described in section 2. In what follows, the most
important points for the installation are listed once again (for details,
see the sections mentioned).
⇒ Setting up instrument section 2.1
⇒ Installing air supply accessories section 2.2.1
⇒ Installing reaction and measuring vessels section 2.2.2
⇒ Mains connection section 2.3
⇒ Connection to PC section 2.4