Metrohm NIRS XDS Transmission OptiProbe Analyzer - Manual (Page 74)

72 ▪▪▪▪▪▪▪
Carefully re-install the back cover, lining up the
captive screws with the mating threaded holes.
Tighten gently by hand.
Do not over-tighten as the screws tend to
become tighter over time. Do not use a
screwdriver, as this will make the screws very
difficult to remove at a later date.
When finished, re-install the power cord if
removed earlier. Re-install the communications
cable as well. Instrument power may be turned
on.
Turn the power switch to the ON position.
In Vision, connect to the instrument, and turn the
lamp ON. The LED panel should show the lamp as
“ON”. The second icon from the right in this
photo indicates the lamp is turned on.
Allow the lamp to warm up for an hour or so, to
let the temperature equilibrate inside the
instrument.