Metrohm NIRS XDS Transmission OptiProbe Analyzer - Manual (Page 23)

▪▪▪▪▪▪▪ 21
1. Load Vision Spectral Analysis Software onto
the computer designated to operate the
XDS instrument.
2. Place the monochromator on the lab bench
in the position shown.
3. Open the right-hand panel of the
instrument. Pull it gently by a fin, until the
catch releases. This panel opens to about a
45-degree angle for access to connectors,
and for filter inspection. Avoid scratches or
damage.
4. Gently thread the AC power cable and
network cable through the lower right
corner of the instrument access area as
shown.
The cables should snap into the black
holder. The innermost position is large, to
fit the power cord. If the power cord is in
the wrong location, the door may not close
fully.
The network cable may go into either of
the other two locations.