Brandmotion 1008-9525-V2 - Manual (Page 8)

INSTALLATION INSTRUCTIONS
9520 and 9525 Instructions 9-24-12.doc 8 of 34
Section 6A: Remove the Compass Circuit Board
(if required)
Follow the steps in Section 6A only if your compass displayed (- -) when the mirror
connector was unplugged in Section 4.
23. Pry mirror apart with a screwdriver (Figure 21).
Figure 21
24. Remove the circuit board from the mirror by
disengaging both connectors. Mark the top of the
circuit board with a permanent marker to insure
proper plug connection later (Figure 22).
Figure 22
25. Wrap the mirror circuit board in the supplied foam
pieces, and cut an opening for the connector
terminals (Figure 23).
Figure 23
26. Make sure ignition is off. Remove the original vehicle
mirror harness connector by cutting the harness
wires 2 inches from the connector. Cut wires one at
a time and strip the insulation from each as these
will be spliced to the supplied interior harness.