Brandmotion 1008-9525-V2 - Manual (Page 4)

INSTALLATION INSTRUCTIONS
9520 and 9525 Instructions 9-24-12.doc 4 of 34
Section 2: Install Camera
5. Remove tailgate handle by loosening two nuts with a
10mm socket (Figure 5).
Figure 5
6. Remove lock cylinder from tailgate handle by pulling
out wire spring clip (Figure 6).
Figure 6
7. Install lock cylinder into supplied tailgate camera
handle with by pushing cylinder into handle. Secure
the cylinder with the wire spring clip.
8. Route camera harness through handle opening in
tailgate to the hole in the bottom of the tailgate
(Figure 7).
Figure 7
9. Install supplied tailgate handle camera into tailgate
by tightening two nuts with 10mm socket (Figure 8).
Figure 8
10. Pass the connector end of the tailgate handle
camera through the 1 inch opening in the pickup
bed and seat grommet.(Figure 9)
Figure 9