Rockwell Automation RECOMM-ENET EtherNet/IP Communications Module - Manual (Page 103)

Viewing the Module’s Web Pages 9-1
C
HAPTER
9
Viewing the Module’s
Web Pages
Chapter 9 provides instructions on how to monitor the module and
connected drive using the web interface.
Future enhancements may result in web pages that look different
than the examples shown in this chapter.
9.1 Accessing the Module’s Main Web
Pages
After configuring the module, you can view its web pages. These
pages present information about the module, the drive to which it is
connected, and the other DPI devices (for example, OIMs or serial
modules) connected to the drive.
Note: Firmware 2.xxx (and earlier) module web pages are
accessed differently than firmware 3.xxx (and later).
• Firmware 2.xxx (and earlier) module — By default the module
web pages are enabled. To disable the web pages, use Bit 0 of
Access Control (54).
• Firmware 3.xxx (and later) module — By default the module web
pages are disabled. To enable the web pages, set the Web Pages
Switch to its “Enable Web” position and reset the module. Web
Enable (55) can be used to display the setting (enabled or
disabled) of this switch.
The module can be configured to automatically send e-mail
messages to desired addresses when selected drive faults occur
and/or are cleared, and/or when the module takes a communication
or idle fault action.
For firmware 2.xxx (and earlier) modules, Bit 1 of Access Control
(54) can be used to protect the configured settings for the email
messaging feature. For firmware 3.xxx (and later)modules, Bit 0 of
Web Features (56) can be used to protect the configured settings.