Rockwell Automation 20D PowerFlex 700S and 700H Frame 10...12 Rectifier Module Replacement Kit - Manual (Page 25)

25
Publication PFLEX-IN023A-EN-P
5. Carefully disconnect the fiber-optic cables from sockets H15 and H16 on
each of the three gate driver boards and carefully set them aside (see
illustration below).
Important: Minimum inside bend radius for fiber-optic cable is 25.4 mm (1.0
in.). Any bends with a shorter inside radius can permanently
damage the fiber-optic cable. Signal attenuation increases with
decreased inside bend radii.
6. Remove the cables from connectors X6 and the DC+/DC- terminals from
the connector at the bottom of the three gate driver boards.
ATTENTION: Hazard of permanent eye damage exists when
using optical transmission equipment. This product emits intense
light and invisible radiation. Do not look into fiber-optic ports or
fiber-optic cable connectors.
X6
H16 H15
+ -
Fiber Optics
Gate driver
board locations
Remove wires from terminals: + –