Rockwell Automation 20D PowerFlex 700S and 700H Frame 10...12 Rectifier Module Replacement Kit User Manual
Page 11
11
5. Remove the bolts that secure the power structure to the drive enclosure (see
Figure 3 below for frame 10 and 12 and Figure 4 on page 12 for frame 11).
6. Follow the instructions in the PowerFlex 700S and 700H High Power
Maintenance Stand, Installation Instructions, publication PFLEX-IN014, to
assemble the maintenance stand.
Note: The maintenance stand is designed for removing power structures from
drives supplied in Rittal TS8 enclosures only. An alternate means of removal
is necessary for other types of enclosures.
7. Remove the power structure by sliding it onto the rails of the maintenance
stand.
Important: Do not pull on any of the cables, terminals or circuit board
mounts when removing the power structure from the
enclosure.
Figure 3 Frame 10 and 12 Drives
Remove bolts
Frame 10 power
structure shown
Remove bolts