Rockwell Automation GV3000/SE 230VAC 30-100HP GP & Vector Drive V6.04 Start-Up and Reference Manual - Manual (Page 13)

VII Preface
This manual is a start-up and programming reference guide for the version 6.04
GV3000/SE (Sensorless Enhanced) drive. The drive can be set up for either volts
per hertz (V/Hz) or vector regulation. This manual provides a start-up procedure for
both.
The start-up procedures are followed by reference information. This information
includes a complete list of all parameters and a description of the keypad/display.
• You will need to know to use the keypad to perform the start-up procedures
described in chapters 1 and 2. If you do not, refer to chapter 3 first.
• For drives that will be set up for V/Hz regulation, go to chapter 1 for the start-up
procedure.
• For drives that will be set up for vector regulation, go to chapter 2 for the start-up
procedure.
• For a description of all the parameters, go to chapter 4.
• For troubleshooting guidelines, go to chapter 5.
• For a description of the drive hardware, refer to the GV3000/SE 230 VAC Drive
Hardware Reference, Installation, and Troubleshooting instruction manual
(D2-3417-1).
New Features in Version 6.04
The GV3000/SE version 6.04 software includes support for the following features:
• Optional outer control loop without requiring an option board (vector control
only). See U.040 through U.048.
• Enhanced analog input configuration. See P.011 (Analog Input Configure).
• Enhanced output relay configuration. See P.013 (Output Relay Configuration).
Getting Assistance from Reliance Electric
If you have any questions or problems with the products described in this instruction
manual, contact your local Reliance sales office. For technical assistance, call
1-800-726-8112.
P
REFACE