Rockwell Automation GV3000/SE 230VAC 30-100HP GP & Vector Drive V6.04 Start-Up and Reference Manual - Manual (Page 100)

4-14 GV3000/SE 230 VAC Drive, Software Reference Version 6.04
Parameter Range: Preset Configurations of Inputs 6, 7, and 8
Digital Input 6 Digital Input 7 Digital Input 8
(Terminal 19)
(Terminal 18) (Terminal 17)
0 = FWD/REV RAMP 1/2 REM/LOC
1 = Not used FWD/REV RAMP 1/2
2 = Not used FWD/REV REM/LOC
3 = Not used RAMP 1/2 REM/LOC
4 = Not used Not used FWD/REV
5 = Not used Not used RAMP 1/2
6 = Not used Not used REM/LOC
7 = Not used Not used Not used
8* = FWD/REV TRQ/SPD REM/LOC
9* = Not used TRQ/SPD REM/LOC
10* = Not used TRQ/SPD FWD/REV
11* = Not used TRQ/SPD RAMP 1/2
12* = Not used Not used TRQ/SPD
Default Setting: 0
Parameter Type: Configurable
Refer also to parameters: P.008 Terminal Strip Speed Reference Source
*Vector regulation only.
ATTENTION: If a maintained start contact is used when the control
source = rE, switching from local to remote from the terminal strip will
cause power to be applied to the motor if the remote start contact is
closed. Stay clear of rotating machinery in this case. Failure to
observe this precaution could result in bodily injury.
An unasserted (open) or asserted (closed) input will select the input functions as
shown in table 4-2. If a function is not configured, the unasserted (open) state will
be applied.
Table 4.2 – Function Selection for Digital Inputs 6, 7, and 8
Input
FWD/REV
RAMP 1/2
REM/LOC
TRQ/SPD
Open (Unasserted)
Forward
Ramp 1
Remote
Torque
Closed (Asserted)
Reverse
Ramp 2
Local
Speed
4.6.2 Second Menu General Parameter Descriptions (P.007 to P.099)
P.007 Terminal Strip Digital Inputs Configure
The GV3000/SE drive
provides multiple
configurations of
digital inputs 6, 7,
and 8 on the terminal
strip. This parameter
determines how
these inputs are
used.
The P.008 (Terminal
Strip Speed
Reference Source)
selection will limit the
selection of P.007
because the P.008
selection may use
one or more of digital
inputs 6 through 8.
!