Rockwell Automation GV3000/SE AC Drive 30-100HP, 230VAC V6.04 Hardware Ref, Install, Troubleshooting - Manual (Page 8)

II GV3000/SE 230 VAC 30-100 HP Drive, Hardware Reference Version 6.04
3.2.5 Verifying Power Module Output Current Rating is Greater
Than Motor Full Load Amps ......................................................... 3-9
Chapter 4 Mounting the Drive, Grounding, and Finding Wire Routing Locations
4.1
Mounting the Drive .................................................................................... 4-1
4.1.1 Verifying the Drive's Watts Loss Rating ...................................... 4-1
4.2 Routing Input, Motor Output, Ground, and Control Wiring
for the Drive ..............................................................................................
4-1
4.3 Grounding the Drive .................................................................................. 4-2
Chapter 5 Installing Input Power Wiring
5.1 Installing Transformers and Reactors (Optional)......................................
5-1
5.2 Installing Fuses for Branch Circuit Protection .......................................... 5-2
5.3 Installing a Required External/Separate Input Disconnect ....................... 5-2
5.4 Installing Power Wiring from the AC Input Line to the Drive's
Power Terminals .......................................................................................
5-5
5.5 Installing Power Wiring from an External DC Bus to the
Drive's Internal DC Bus Terminals ............................................................
5-5
Chapter 6 Installing Output Power Wiring
6.1
Installing Output Contactors (Optional) .................................................... 6-1
6.2 Installing Mechanical Motor Overload Protection (Optional) .................... 6-1
6.3 Installing Output Wiring from the Drive Output Terminal to the Motor ..... 6-1
Chapter 7 Wiring the Regulator Board Terminal Strip
7.1 Stopping the Drive ....................................................................................
7-6
7.2 Wiring the Encoder Feedback Device (FVC Regulation Only) ................. 7-6
7.3 Wiring the Signal and Control I/O ............................................................. 7-9
Chapter 8 Completing the Installation
8.1 Checking the Installation ...........................................................................
8-1
8.2 Powering Up After Installation is Complete .............................................. 8-2
Chapter 9 Troubleshooting the Drive
9.1
Test Equipment Needed to Troubleshoot ................................................. 9-1
9.2 Drive Alarms and Faults ........................................................................... 9-1
9.3 Verifying That DC Bus Capacitors are Discharged .................................. 9-1
9.4 Checking Out the Power Module with Input Power Off ............................ 9-2
9.5 Replacement Parts ................................................................................... 9-4
Appendix A Technical Specifications .................................................................................... A-1
Appendix B 30-100 HP GV3000/SE System Wiring Diagram ............................................... B-1