Rockwell Automation WebPak 3000 User Guide - Manual (Page 61)

Troubleshooting the Drive Using the OIM 7-3
7.2.1 Reviewing the Fault and Alarm Logs
You can review the fault and alarm logs to help identify the problem and determine
when it occurred.
Step 1. Select Review Log from the Fault or Alarm Menu. The screen shown in
figure 7.5 is displayed. If the log is empty, “Log is Empty” is displayed.
The first line in the Review Log is the most recent fault or alarm. If a fault or
alarm is detected while you are in the log, the display is updated to show the
new entry.
Step 2. To view more information about a particular fault or alarm, move the cursor
to that fault or alarm and press . A detail screen is displayed, similar to
the examples shown in figures 7.6 and 7.7.
Figure 7.5 – Example of a Fault Log Screen
Figure 7.6 – Example of a Fault Detail Screen
Figure 7.7 – Example of an Alarm Detail Screen