Rockwell Automation WebPak 3000 User Guide - Manual (Page 54)

6-2 WebPak 3000 OIM User Guide
6.1.2 Selecting the Outputs to Monitor
You can view one of two monitor mode screens. The first monitor mode screen shows
all four monitored outputs. The second monitor mode screen shows the motor speed
and motor load without labels, but in larger text so the values can be read from a
distance. You can switch between the monitor mode screens at any time.
To select monitor mode:
Step 1. Press until the key indicator switches from PROGRAM to MONITOR . The
monitor mode screen with four outputs is displayed, as shown in figure 6.1.
Step 2. To display the two-output monitor mode screen, press again. The
screen shown in figure 6.2 is displayed. You cannot change the value of the
reference in this screen.
Step 3. To go to program mode, press again. As you press , you cycle
between program mode, the four-output monitor mode screen, and the
two-output monitor screen.
6.1.3 Using Help in Monitor Mode
Pressing in monitor mode displays the labels for the drive status indicators in
the selected language. To return to monitor mode, press .
6.2 Selecting the Control Source
The control source selects the source of the drive control signals. Control signals
include drive operating signals, such as run and jog, and the drive reference. The
control source is selected using .
Figure 6.2 – Second Monitor Mode Screen