Rockwell Automation WebPak 3000 User Guide User Manual

Page 2

The information in this manual is subject to change without notice.

Throughout this manual, the following notes are used to alert you to safety considerations:

Important: Identifies information that is critical for successful application and understanding of the product.

ATTENTION: Identifies information about practices or circumstances that can lead to personal
injury or death, property damage, or economic loss.

Reliance, WebPak, and AutoMax are trademarks of Rockwell Automation.

ATTENTION: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, or service this equipment.
Read and understand this section in its entirety before proceeding. Failure to observe this
precaution could result in severe bodily injury or loss of life.

ATTENTION: Pressing

on the

OIM

immediately starts the motor if the control

source is set to

KEYPAD

. Make sure the motor and driven machinery are safe to start before

pressing either of these keys. Failure to observe this precaution could result in severe bodily injury
or loss of life.

ATTENTION: The drive can operate at and maintain zero speed. The user is responsible for
assuring safe conditions for operating personnel by providing suitable guards, audible or visual
alarms, or other devices to indicate that the drive is operating or may operate at or near zero
speed. Failure to observe this precaution could result in severe bodily injury or loss of life.

ATTENTION: The user must provide an external, hardwired emergency stop circuit outside of the
drive circuitry. This circuit must disable the system in case of improper operation. Uncontrolled
machine operation may result if this procedure is not followed. Failure to observe this precaution
could result in bodily injury.

ATTENTION: The user is responsible for conforming with all applicable local, national, and
international codes. Failure to observe this precaution could result in damage to, or destruction
of, the equipment.