Rockwell Automation WebPak 3000 User Guide - Manual (Page 45)

Using Quick Start 5-9
TOP LINE SPEED (P.020)
Specifies the
maximum line speed
in feet per minute. Parameter Range: 0 to 5000 FPM
Default Setting: 500 FPM
Parameter Type: Configurable
!
ATTENTION: Do not allow the motor to exceed the maximum safe speed
of the motor or driven equipment as determined by the equipment
manufacturer. Failure to observe this precaution could result in bodily
injury.
MOTOR RATED ARM AMPS (P.008)
Identifies the rated
armature current as
is appears on the
motor nameplate. Parameter Range: 0 to 3000.0 AMPS
Default Setting: 8.0 AMPS
Parameter Type: Configurable
!
ATTENTION: MOTOR RATED ARM AMPS (P.008) must be less than the
motor rated armature amps or drive current rating listed on the motor
nameplate. If this is configured incorrectly, overcurrent or excess heating
of the motor could result. Failure to observe this precaution could result
in damage to, or destruction of, the equipment.
MOTOR RATED ARM VOLTS (P.009)
Identifies the rated
armature voltage as it
appears on the motor
nameplate. Parameter Range: 160 to 1000 VOLTS
Default Setting: 240 VOLTS
Parameter Type: Configurable
!
ATTENTION: The incorrect configuration of MOTOR RATED ARM VOLTS
(P.009) can cause an overspeed condition. This parameter must be
configured by a qualified person who understands the significance of
configuring it accurately. Failure to observe this precaution could result
in bodily injury.