Rockwell Automation WebPak 3000 User Guide User Manual
Page 32

4-6
WebPak 3000 OIM User Guide
Important: To exit a parameter entry screen without making changes, press
.
To change a parameter value:
Step 1. Go to the menu that contains the parameter you want to change by using
the procedure in section 4.2.3, “Accessing the Parameters”.
Step 2. Press
to move the cursor until it points to the parameter. Press
.
Step 3. You will see either:
•
the existing value with the cursor blinking at the far right digit, like the
screen shown in figure 4.8.
•
a list of options, like the screen shown in figure 4.9.
Step 4. If the existing value is shown, go to step 5. If you see a list of options:
a. Move the cursor to the option you want to select.
b. Press
to accept the option.
c. Go to step 7.
Step 5. If you see the existing value:
a. Use
and
to move the cursor to the number or sign you want
to change.
b. Press
or
to change the number or sign. When changing:
•
If the right-most digit is increased past 9, the digit to the left is
increased by one. Incrementing any other digit does not increase the
digit to the left. For example, if 19 is displayed, press
to change
the value to 200. If 1 9 is displayed,
changes the value to 109.
•
If the field is blank and you fill in the left-most digit, the digits to the right
are automatically filled in with zeros.
•
You cannot enter a number out of the parameter’s range. The drive
clamps values to a minimum and maximum.
•
Press
to restore the previous value. You can then either change
the value or press
again to exit the parameter entry screen
without accepting any changes.
Figure 4.9 – Parameter Entry Screen with a List of Options
$QDORJ ,2
$1$/2*
5(*,67(5
7(16,21 6(737 6,* 7<3(
5(*,67(5
9
9