Rockwell Automation 2711P-xxxx PanelView Plus 6 Terminals User Manual - Manual (Page 76)

76 Rockwell Automation Publication 2711P-UM006C-EN-P - April 2013
Chapter 3 Configuration Mode
View and Clear the System
Event Log The System Event Log dialog box displays warnings, errors, and events logged by
the terminal. The log provides a time stamp of when each event occurred and text
describing the event. If the event log is full when a new event occurs, the oldest
entry is removed to accommodate the new event.
1. Press Terminal Settings>System Event Log.
2. Select an event and press More Details to display log details for that event.
3. Press Clear All to clear all system event logs.
4. Press Close.
System Information You can view terminal and firmware revision information for software installed
on a terminal. This information can be useful during troubleshooting.
View Terminal Information
This read-only information is provided for the terminal:
• Total power on time in minutes
• Processor temperature (700 to 1500 terminals only)
• Battery voltage and state
• Memory allocated and used on terminal
• RAM memory used during runtime
Follow these steps to display terminal information.
1. Press Terminal Settings>System Information>Terminal Information.