Rockwell Automation 2711P-xxxx PanelView Plus 6 Terminals User Manual - Manual (Page 134)

134 Rockwell Automation Publication 2711P-UM006C-EN-P - April 2013
Chapter 5 Install and Replace Components
Remove the Product ID Label You can replace the product ID label on the terminal with a custom label.
1. Remove the Allen-Bradley label by using your fingers or a tweezers.
2. Clean area with damp cloth and isopropyl alcohol.
3. Remove adhesive backing of new label and affix to the same location.
Replace the Keypad Legend
Inserts Legend strips are available as separate catalog numbers for keypad terminals,
except for the 400 keypad terminals. One side of the legend strips have default
key legends; the other side is blank for creating custom legends.
600 Terminals
The legend inserts for function keys F1…F10 are accessible from the back of the
unit and can be replaced with the terminal mounted in the panel.
Follow these steps to replace the legend insert.
1. Disconnect power to the terminal.
2. From the rear of the unit, pull the legend strip from the slot.
3. Slide the new legend insert into the same slot.