Start-up options, De. refer to, Start-up options on – Rockwell Automation 2711P-xxxx PanelView Plus 6 Terminals User Manual User Manual
Page 51: Refer to
Rockwell Automation Publication 2711P-UM006C-EN-P - April 2013
51
Configuration Mode
Chapter 3
Start-up Options
You can specify what action the terminal takes on startup or a reset.
Disable FactoryTalk View ME Station Software on Startup
Terminals with extended features and file viewers are typically configured to
launch the Windows desktop on startup. This means you must disable
FactoryTalk View ME Station from launching on startup.
Follow these steps to disable FactoryTalk View ME Station on startup so that the
desktop can launch.
1. Press Terminal Settings>Startup Options.
2. Press On Startup until ‘Do not start FactoryTalk View ME Station’ is
selected.
3. Press OK.
This Start-up Option
Performs This Action
Typical System
Do not start FactoryTalk View ME
Station
Launches the Windows Explorer desktop on startup.
Open
Go to Configuration Mode
Launches FactoryTalk View ME Station Configuration
mode on startup. This is the initial, factory default setting.
Closed
Run Current Application
Runs the FactoryTalk View ME application loaded in the
terminal on startup.
Closed
IMPORTANT
When desktop access is restricted, the start-up option must be set to Run
Current Application or Go to Configuration Mode (default). Refer to
details on how to enable or disable desktop access.
TIP
The desktop can also be launched from FactoryTalk View ME Station
Configuration mode by pressing Exit.
TIP
When disabling FactoryTalk View ME Station, desktop access must be set to
allow or you get a warning. Refer to