Rockwell Automation 2711P-xxxx PanelView Plus 6 Terminals User Manual - Manual (Page 119)

Rockwell Automation Publication 2711P-UM006C-EN-P - April 2013 119
Chapter
5
Install and Replace Components
Required Tools You need a #1 and #2 Phillips screwdriver to replace some of the components.
Topic Page
Install or Replace the Logic Module 120
Install or Replace a Communication Module 121
Replace the Display Module 123
Replace the Bezel 124
Replace the Backlight 126
Replace the Battery 130
Install the AC Power Supply Module 132
Remove the Product ID Label 134
Replace the Keypad Legend Inserts 134
Load an SD Card 135
Clean the Display 136
ATTENTION: Prevent Electrostatic Discharge
This equipment is sensitive to electrostatic discharge, which can cause internal
damage and affect normal operation.
Follow these guidelines when you handle this equipment:
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wriststrap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
• Use a static-safe workstation, if available.
• Store the equipment in appropriate static-safe packaging when not in use.
SHOCK HAZARD: Disconnect power from the terminal before installing or
replacing any components. Failure to disconnect power can result in electrical
shock or damage to the terminal.