Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 72)

Installing Your
Programmable Controller
Chapter 4
4-33
For a single-conductor wire or multi-conductor cable, perform the
following steps. For a multi-conductor shielded cable, proceed to the next
section (page 4-34).
SingleĆConductor Wire or MultiĆConductor Cable
1. Strip about 3/8 inch insulation to expose the end of the wire
Strip about 3/8 inch insulation to expose the wire
2. Loosen a terminal screw and place the wire under the pressure plate
of the terminal.
10604ĆI
3. Secure the terminal screw.