Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 35)

Hardware Features
Chapter 3
3-9
1. Connect one end of the PLC-2 Program Panel Interconnect Cable
(cat. no. 1772-TC) to CHANNEL A at the rear of the
industrial terminal.
2. Connect the other end of the cable to the socket labeled INTFC at the
front of the processor.
3. Place the PLC-2 Family Keytop Overlay (cat. no. 1770-KFA)
(Figure 3.5) onto the keyboard.
Figure 3.5
A PLCĆ2 Family Keytop Overlay
MODE
SELECT
DATA
INIT
EXPAND
ADDR
SBR
T.END
-(RET)-
-(JSR)-
LBL
-(JMP)-
EAF
-(SCT)-
CONVERT FILE SEQ SHIFT
REG
BLOCK
X-FER
RECORD RUNG SEARCH -(
÷
)- -[ G ]- -[ I ]- -(CTU)- -(TON)- -( L )-
A
7
B
8
C
9
DISPLAY INSERT REMOVE -( X )- -[ = ]- -[ L ]- -(CTD)- -(TOF)- -( U )-
D
4
E
5
F
6
HELP
SHIFT
CLEAR
MEMORY
CANCEL
COMMAND
-( – )- -[ < ]- -[ B ]- -(CTR)- -(RTO)- -(MCR)- 1 2 3
-( + )- -(PUT)- -(IOT)- -(ZCL)- -(RTR)- -( )- FORCE
OFF
FORCE
ON
0
4. Plug the ac power cord of the terminal into the ac power source.
5. If using a 1772-LWP, -LXP, or -LZP processor, plug the power cord
into the ac power source.
6. Turn the power switch on the front of the industrial terminal to the
ON position.
7. Turn the power switch of the 1772-LWP, -LXP, -LZP processor to the
ON position.