Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 34)

Hardware Features
Chapter 3
3-8
We recommend that you use a series C, revision C or later 1770-T3
terminal; earlier versions do not provide full functionality. You can use
a 1770-T1 or 1770-T2 industrial terminal to program the processors;
however, only instructions supported by these terminals can
be programmed.
ATTENTION: Programs entered using a 1770-T3 Industrial
Terminal must not be edited with either a 1770-T1 or a 1770-T2
industrial terminal. Such editing could result in unexpected
operation with possible damage to equipment and injury
to personnel.
When using 1-slot or 1/2-slot addressing, use a series C 1770-T3 terminal
to obtain full compatibility with the processor. With this series terminal,
you can perform the following operations in rack 1, 2, 3 or 4.
immediate I/O
block transfer
full forcing
Installing the 1770ĆT3 Terminal
Before you start to program your processor make sure all of your
peripheral equipment is installed properly. Follow these basic instructions
to connect the 1770-T3 terminal to the processor (Figure 3.4).
Figure 3.4
The Connections Between an Industrial Terminal and a Processor
Channel A
Industrial Terminal
(rear view)
Program Panel
Interconnect Cable
Interface
MiniĆPLCĆ2/02, Ć2/16, Ć2/17
PLCĆ2 Family
10249