Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 53)

Installing Your
Programmable Controller
Chapter 4
4-14
Installing your processor involves twelve steps. Perform these steps
in order.
1. Mounting the backpanel (page 4-14)
2. Mounting and grounding components on the backpanel (page 4-15)
3. Setting the switches within the switch group assembly (page 4-22)
4. Installing keying bands and field wiring arms (page 4-24)
5. Installing I/O modules (page 4-26)
6. Installing backup battery (page 4-28)
7. Installing the EEPROM memory module (page 4-29)
8. Installing the processor (page 4-31)
9. Installing the power supply (page 4-31)
10. Wiring field wiring arms (page 4-32)
11. Connecting power to the processor or power supply (page 4-37)
12. Connecting the industrial terminal (page 4-42)
Electrostatic Discharge
Electrostatic discharge can damage integrated circuits or semiconductors in
this processor if you touch backplane connector pins. Avoid electrostatic
damage by observing the following precautions:
Touch a grounded object to discharge yourself before handling the
processor.
Do not touch the backplane connector or connector pins.
When not in use, keep the module in its static-shield bag.
ATTENTION: Electrostatic discharge can degrade
performance or damage the processor. Handle as stated above.
Failure to observe this caution may cause damage to
the processor.
Stud mounting of a backpanel to the back wall of an enclosure
Bolt mounting of an I/O chassis or ground bus to the backpanel
Stud mounting of an I/O chassis or ground bus to the backpanel
Step 1 - Mounting
the Backpanel