Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 358)

MR,n
RETURN
ESC
RETURN
MD,n
ESC
RETURN
Report Generation
Chapter 23
23-7
Message Report - MR
Accessible in any mode, the message report command prints a message
with the current data table value or bit status that corresponds to an address
between the delimiters. For example, the message report command gives
the following: bit 013/05 is off and counter 030 accumulated value is 000.
You must be in report generation.
MR,n appears on the screen.
n = message number
SR6 IS OFF IN CYCLE 000
Returns the display to the ladder diagram.
Message Delete - MD
Accessible only in the Program or Remote Program mode, the message
delete command is used to delete messages from memory. This command
is accessed by:
You must be in report generation.
MD,n appears on the screen
n = message number
The prompt DELETION IN PROGRESS appears on the screen.
The message delete command cannot be terminated before completion. It
terminates after the message has been cleared from memory and a
MESSAGE DELETED prompt is printed.
The display returns to the ladder diagram.
Important: Deleting MS,0 does not delete data in other stored messages.