Rockwell Automation 1732E-IR4IM12R ArmorBlock Dual-Port EtherNet/IP 4-Point Thermocouple and RTD - Manual (Page 62)

54 Rockwell Automation Publication 1732E-UM004A-EN-E - July 2012
Chapter 6 Troubleshoot the Module
Check for Faults In addition to the status indicators on the module, RSLogix 5000 software alerts
you to fault and other conditions in one of three ways:
Indicator Status for the Modules
Indicator Status Description
Module
status Off No power applied to the device.
Flashing red/
green The module is performing POST (Power-On Self Test), which
completes within 30 s.
Green Device operating normally.
Flashing red Module has experienced a recoverable fault. Possible minor
faults include the following:
• IP Address switches do not match configuration in use.
• The device has completed a reset to factory default request
due to the switches being set to 888 at power up, and a
power cycle is required.
• The device is performing a firmware flash update.
• Channel fault
• No auxiliary power
Red Unrecoverable fault – may require device replacement.
Network
status Off The device is not initialized or the module does not have an IP
address.
Flashing green The device has no CIP connections. The device has an IP address,
but no CIP connections are established.
Green Device is online, has an IP address. CIP connections are
established.
Flashing red One or more connections have timed out.
Red The module has detected that its IP address is
already in use.
Flashing red/
green The module is performing a power-on self test (POST).
Network link
status
(Link 1/Link 2) Off No link established.
Green Link established on indicated port at 100 Mbps.
Flashing green Link activity present on indicated port at 100 Mbps.
Yellow Link established on indicated port at 10 Mbps.
Flashing yellow Link activity present on indicated port at 10 Mbps.
Auxiliary
Power status Off Auxiliary power off or not connected.
Green Auxiliary Power applied to device.
I/O status Off The input channel is inactive, can be calibrated.
Flashing Green Channel is calibrating.
Green Normal operation, inputs being scanned.
Flashing Yellow Thermistor fault.
Flashing Red Fault. Overrange, underrange, or process alarm is present.
Red No power is detected.