Rockwell Automation 1732E-IR4IM12R ArmorBlock Dual-Port EtherNet/IP 4-Point Thermocouple and RTD - Manual (Page 51)

Rockwell Automation Publication 1732E-UM004A-EN-E - July 2012 43
Configurable Features for the Thermocouple and RTD Input Modules Chapter 4
78 Channel 3 Enable Alarm Latch
79 Channel 3 Disable Alarms
80 Channel 3 RTD Type
81 Channel 3 Temperature Scale
82…83 Reserved (Ignore)
84 Notch Filter
85 Reserved (Ignore)
1732E-IT4IM12R – Produced Data Structure for Thermocouple Input
Configuration
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0…3 Reserved (must be zero)
4…5 Channel 0 Data
6…7 Channel 1 Data
8…9 Channel 2 Data
10…11 Channel 3 Data
12 Channel 0 Status
(1)
(1) This parameter is in Byte and has the following structure:
Bit 0 = Fault; Bit 1 = Calibration; Bit 2 = Low Alarm; Bit 3 = High Alarm; Bit 4 = Low Low Alarm; Bit 5 = High High
Alarm; Bit 6 = Underrange; Bit 7 = Overrange
13 Channel 1 Status
(1)
14 Channel 2 Status
(1)
15 Channel 3 Status
(1)
16 Cold Junction Temperature Channel 0 (low byte)
17 Cold Junction Status
Channel 0
(2)
(2) Cold junction status is defined below. When a fault is detected, the Cold Junction Temperature is set to zero (thus,
a word value of 0xC000 indicates that the cold junction is enabled, but no thermistor data is available).
00 = No fault; 01 = Underrange; 02 = Overrange; 03 = No thermistor detected
Cold Junction Temperature Channel 0 (high byte, low 6 bits)
18 Cold Junction Temperature Channel 1 (low byte)
19 Cold Junction Status
Channel 1
(2)
Cold Junction Temperature Channel 2 (high byte, low 6 bits)
20 Cold Junction Temperature Channel 2 (low byte)
21 Cold Junction Status
Channel 2
(2)
Cold Junction Temperature Channel 2 (high byte, low 6 bits)
22 Cold Junction Temperature Channel 3 (low byte)
23 Cold Junction Status
Channel 3
(2)
Cold Junction Temperature Channel 3 (high byte, low 6 bits)
1732E-IR4IM12R – Configuration Data Structure for RTD Input
Configuration
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0