Rockwell Automation 1732E-IR4IM12R ArmorBlock Dual-Port EtherNet/IP 4-Point Thermocouple and RTD - Manual (Page 22)

14 Rockwell Automation Publication 1732E-UM004A-EN-E - July 2012
Chapter 3 Configure Your Thermocouple and RTD Input Modules with RSLogix 5000 Software
Set Up the Hardware In this example, a ControlLogix chassis contains the Logix5565 processor in slot
1 and a 1756-EN2T bridge module in slot 3. The 1732E ArmorBlock module is
mounted remotely.
To work along with this example set up your system as shown.
• Note that in the example application, the Logix5565 controller and
1756-EN2TR module (firmware version 2.3 or higher) are assumed to be
in the slots shown.
• Verify the IP addresses for your programming terminal, 1756-EN2TR
module and 1732E ArmorBlock Ethernet module.
• Verify that you connected all wiring and cabling properly.
• Be sure you configured your communication driver (for example,
AB_ETH-1 or AB-ETHIP-1) in RSLinx software.
Logix5565
1756-EN2T
EtherNet/IP
Logix5565
Local
Chassis 1732E
ArmorBlock
Logix5565
Controller (slot 1)
1756-EN2T
192.168.1.20 (slot 3)
Data
Switch
192.168.1.100
Programming
Terminal
0
1732E ArmorBlock
Ethernet Module
192.168.1.3
44971
3 2 Slot 1
Embedded
Technology