Rockwell Automation 1732E-IR4IM12R ArmorBlock Dual-Port EtherNet/IP 4-Point Thermocouple and RTD - Manual (Page 19)

Rockwell Automation Publication 1732E-UM004A-EN-E - July 2012 11
Install Your ArmorBlock Module Chapter 2
Ethernet Connector
D-Code Micro Network Female Connector
Power Connectors
Attach the micro-style 4-pin connector to the micro-style 4-pin receptacle as
shown below.
Micro-style 4-Pin Input Male Receptacle
The power required by the module is based on a 4-pin micro-style connector
system. Power can be daisy chained through the module either left to right or
right to left. The standard configuration is with Module/Auxiliary power
entering the module on the left connector.
IMPORTANT Use the 1585D–M4DC–H: Polyamide small body unshielded mating
connectors for the D-Code M12 female network connector.
Note that the distance between the center of each Ethernet connector
is 16.2 mm (see Mounting Dimensions on page
9 ). Rockwell Automation
recommends the use of suitable cable based on this measurement.
Some of the recommended cables are 1585D-M4TBJM-x and 1585D-
M4TBDM-x for daisychains.
IMPORTANT Use two twisted pair CAT5E UTP or STP cables.
4 2
3
1
5
(View into connector 1)
Pin 1 M12_Tx+
Pin 2 M12_Rx+
Pin 3 M12_Tx-
Pin 4 M12_Rx-
Pin 5 Connector shell shield GND
44808
D-Code
M12 Pin Wire Color Signal 8-way
Modular
RJ45 Pin
1 White-
orange TX+ 1
2 White-green RX+ 3
3 Orange TX- 2
4 Green RX- 6
1
4
3
2
Male Input Female Output
(View into receptacle)
Pin 1 Auxiliary power+
Pin 2 Module power+
Pin 3 Module power-
Pin 4 Auxiliary power-
45764
3
4
1
2
45763