Rockwell Automation 1732E-IR4IM12R ArmorBlock Dual-Port EtherNet/IP 4-Point Thermocouple and RTD - Manual (Page 15)

Rockwell Automation Publication 1732E-UM004A-EN-E - July 2012 7
Chapter
2
Install Your ArmorBlock Module
Overview This chapter shows you how to install and wire the 1732E ArmorBlock
EtherNet/IP Dual Port 4-Point Thermocouple and RTD Input modules. The
only tools you require are a flat or Phillips head screwdriver and drill. This
chapter includes the following topics:
Install the Module To install the module:
• Set the network address
• Mount the module
• Connect the I/O, Network, and Auxiliary cables to the module.
Set the Network Address
The I/O block ships with the rotary switches set to 999 and DHCP enabled. To
change the network address, you can do one of the following:
• adjust the node address switches on the front of the module.
• use a Dynamic Host Configuration Protocol (DHCP) server, such as
Rockwell Automation BootP/DHCP.
• retrieve the IP address from nonvolatile memory.
The I/O block reads the switches first to determine if the switches are set to a
valid number. To set the network address:
1. Remove power.
2. Remove the switch dust caps.
3. Rotate the three (3) switches on the front of the module using a small
blade screwdriver.
4. Line up the small notch on the switch with the number setting you wish to
use.
Valid settings range from 001…254.
Topics Page
Install the Module 7
Set the Network Address 7
Mount the Module 9
Wire the Module 10