Rockwell Automation 1732E-IR4IM12R ArmorBlock Dual-Port EtherNet/IP 4-Point Thermocouple and RTD - Manual (Page 18)

10 Rockwell Automation Publication 1732E-UM004A-EN-E - July 2012
Chapter 2 Install Your ArmorBlock Module
and the lock washer as shown in the mounting illustration. Torque the mounting
screws to 0.68 Nm (6 lb-in.).
High Vibration Area Mounting
Wire the Module The 1732E-IT4IM12R and 1732E-IR4IM12R modules have 5-pin micro-style
M12 I/O connectors. We provide caps to cover the unused connectors on your
module. Connect the quick-disconnect cord sets you selected for your module to
the appropriate ports.
I/O Connectors
(1)
Micro-style M12 5-Pin Input Female Connector – 1732E-IT4IM12R
Micro-style M12 5-Pin Input Female Connector – 1732E-IR4IM12R
45768
Lock washer
Flat washer
(1) Only 4 of the 5 pins are active. The center pin (5) is internally tied to signal ground to minimize
external noise pickup.
3
4
1
2
5
45868
(View into connector)
Pin 1CJC +
Pin 2TC +
Pin 3CJC -
Pin 4TC -
Pin 5No Connect
A
C
B
3
4
1
2
5
45868
(View into connector)
Pin 1No Connect
Pin 2A
Pin 3B
Pin 4C
Pin 5No Connect