Rockwell Automation 1732E-IR4IM12R ArmorBlock Dual-Port EtherNet/IP 4-Point Thermocouple and RTD - Manual (Page 21)

Rockwell Automation Publication 1732E-UM004A-EN-E - July 2012 13
Chapter
3
Configure Your Thermocouple and RTD Input
Modules with RSLogix 5000 Software
Introduction This chapter guides you through the steps required to configure your modules
using the RSLogix 5000 software. Note that the modules presented in this
chapter can be configured using RSLogix 5000 software, version 20, or later.
Configuring the two modules through RSLogix 5000 involve the same general
procedure. Note, however, that the two modules do not have exactly similar
Module Definition properties. These are distinctly covered in this chapter.
Topic Page
Set Up the Hardware 14
Create the Example Application 15
Configure Your I/O Module 16
Overview of the Configuration Process through RSLogix 5000 16
Add a New Bridge and Module to Your RSLogix 5000 Project 16
Download the Program to Your Controller 20
Edit Your Module Configuration 21
Chapter Summary 33