Rockwell Automation 1756-OF8I ControlLogix Eight-channel Isolated Analog I/O Modules - Manual (Page 25)

Rockwell Automation Publication 1756-UM540A-EN-P - May 2014 25
ControlLogix Isolated Analog I/O Module Features Chapter 2
Configurable Software
Use one of the following software applications with your module:
• RSLogix 5000 software, versions 18…20
• Logix Designer application, version 21 or later
All module feature configuration begins in the I/O configuration portion of the
Logix Designer application. In addition to enable or disable module features, you
can use the application to interrogate any module for the following
module information:
• Serial number
• Revision information
• Catalog number
• Vendor identification
• Error/fault information
• Diagnostic counters
For more information on configurable software and its use, see the
following sections:
• Preface
• Chapter 7, Configure ControlLogix Isolated Analog I/O Modules
• Chapter 8, Calibrate the ControlLogix Isolated Analog I/O Modules
• Chapter 9, Troubleshoot Your Module
IMPORTANT You must install Add-on Profiles (AOP) to use the modules in any Logix
Designer application or RSLogix 5000 software project.
This publication describes configuration with Logix Designer
application. AOPs are available at: