Rockwell Automation 22-WIM-N1 DSI Wireless Interface Module - Manual (Page 51)

Troubleshooting 4-5
To clear the event queue
1. Access the event queue using a configuration tool.
2. Set the value of 1 > Clr Event Queue to Enable, and then press
Enter to clear the event queue.
If you encounter unexpected communications problems or are creating
an application that uses DF1 data, you can view the communications
statistics in the WIM. Parameter 10 - [DF1 Packets Sent] and
Parameter 11 - [DF1 Packets Rcvd] store this data.
To view and clear DF1 data, you must access the main menu in the WIM
firmware.
To view DF1 data
1. Access the parameters in the WIM using a configuration tool.
2. Scroll through the DF1 Parameters 10 and 11, which contain DF1
data. For a description of each parameter, refer to Appendix B , WIM
Parameters .
To clear DF1 data
1. Access the parameters in the WIM using a configuration tool.
2. Set the value of Parameter 09 - [Clear DF1 Counts] to “1 = Clear
Counts,” and then press Enter to clear the DF1 data.
Viewing and Clearing DF1 Communication Statistics