Rockwell Automation 20D PowerFlex 700S Phase II Drive Frames 1...6 Installation Instructions - Manual (Page 7)

Rockwell Automation Publication 20D-IN024C-EN-P - July 2013 7
PowerFlex 700S Adjustable Frequency AC Drive - Phase II Control
Product Safety
Class 1 LED Product
ATTENTION: An incorrectly applied or installed drive can result in component damage or a reduction in product life. Wiring or
application errors such as under sizing the motor, incorrect or inadequate AC supply, or excessive surrounding air temperatures may
result in malfunction of the system.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts and assemblies. Static control precautions are
required when installing, testing, servicing or repairing this assembly. Component damage may result if ESD control procedures are
not followed. If you are not familiar with static control procedures, reference Guarding Against Electrostatic Damage, publication
8000-4.5.2 or any other applicable ESD protection handbook.
ATTENTION: Configuring an analog input for 0-20 mA operation and driving it from a voltage source could cause component
damage. Verify proper configuration prior to applying input signals.
ATTENTION: A contactor or other device that routinely disconnects and reapplies the AC line to the drive to start and stop the
motor can cause drive hardware damage. The drive is designed to use control input signals that will start and stop the motor. If an
input device is used, operation must not exceed one cycle per minute or drive damage will occur.
ATTENTION: Hazard of permanent eye damage exists when using optical transmission equipment. This product emits intense
light and invisible radiation. Do not look into module ports or fiber optic cable connectors.