Rockwell Automation 20D PowerFlex 700S Phase II Drive Frames 1...6 Installation Instructions - Manual (Page 65)

Rockwell Automation Publication 20D-IN024C-EN-P - July 2013 65
PowerFlex 700S Adjustable Frequency AC Drive - Phase II Control
Wiring the Stegmann Hi-Resolution Feedback Option Card to an Encoder
Terminal block P1 contains connection points for a Stegmann Hiperface®
encoder. This terminal block resides on the Hi-Resolution Encoder Feedback
Option card.
Stegmann Hi-Resolution Encoder Option Terminal Designations
TIP Remember to route wires through the sliding access panel at the bottom of the
control assembly.
Terminal Signal Description
12 POWER COMMON Power supply for encoder interface.
11 POWER
10 REFSIN Negative Sine signal.
9 +SIN Positive Sine signal.
8 REFCOS Negative Cosine signal.
7 +COS Positive Cosine signal.
6 SHIELD Connection point for encoder cable
shield.
5 SHIELD
4 N/C Not connected.
3 N/C
2 DATA+ (RS 485) Positive DH485 terminal.
1 DATA- (RS 485) Negative DH485 terminal.
12
3
4
5
6
7
8
9
10
11
12