beautypg.com

Tail/brake lights: replacing the lamp assembly – MacDon R85 Rotary Disc 16 Foot Pull-Type User Manual

Page 220

background image

MAINTENANCE AND SERVICING

Tail/Brake Lights: Replacing the Lamp Assembly

Follow these steps to replace tail/brake light lamp assembly:

1. Cut cable tie (A) securing harness covering to light (B).

2. Retrieve connections (C) from inside harness covering

approximately 6 in. (150 mm) from light and disconnect
wires. If necessary, remove tape.

3. Remove nut (D) securing light to frame and remove

light (B). Pull wires through hole in frame.

4. Feed connectors of new light (B) through hole in

bracket and position light onto frame.

5. Install nut (D) and tighten.

6. Connect wires to connectors (C) in harness and

secure harness covering with tape and cable tie (A)
as required.

Figure 8.137

169456

210

Rev. D