MacDon A40-D - Manual (Page 39)

SECTION 6 OPERATION
169000 / 169040
37
Revision E
o. Open header LH driveshield.
p. Check hose routing at the reel motor. The hose
routing depends on which windrower model the
header is being attached to. The header is
factory-configured for M150, M155, and M200
windrowers.
q. Change hoses as follows if header is being
mounted on a M100, M105, or M205 windrower:
1. Disconnect hose (C) at tee (E).
2. Disconnect hose (D) at reel motor.
3. Disconnect tee (E) at motor lower port and
relocate to upper port.
4. Connect hose (D) to tee (E).
5. Connect hose (C) to motor lower port.
FACTORY CONFIGURATION
M150, M155 AND M200
C
D
E
M100, M105, M205 CONFIGURATION
C
D
E