Opticon PHL 8000 - Manual (Page 47)

Opticon
PHL 8000 series
User Manual
47
2.5. Power Management
2.5.1. Suspend Mode
The PDT will go into a suspended mode when it is idle for a period of time. The
idle duration can be customized using the Power control panel (refer to Figure 2-
28: Schemes tab).
Suspend mode works and looks just like you have turned the unit off. Press the
Power key
to suspend the PDT; press the Power key again for the PDT to
resume its previous state.
Use the Battery power control panel to set the duration to switch state to
Suspend mode when system using battery power. This will save battery power
when PDT is not in use.
Figure 2-28: Schemes tab
Suspending:
The following conditions will suspend:
• Press the key while the unit is on.
• The duration timer of item Switch state to Suspend expires, which
indicates that there has been no use for a specified of time.
• The battery pack is completely discharged.