Metal Sales Snap-Loc 24 Installation - Manual (Page 31)

© Metal Sales Manufacturing Corporation / Subject to change without notice. 10/99
SNAP-LOC 24
30
INSTALLATION OF GUTTER DRIP FLASHING
GUTTER DRIP
FLOATING RAKE ANGLE
GUTTER DRIP
DOUBLE BEAD
TAPE SEALANT
SNAP-LOC
SCULPTURED EAVE
GUTTER DRIP
TEMPORARILY
FASTEN GUTTER
DRIP
STEPS
1. Place the Gutter Drip flashing along the eave on top of the upper leg of the Eave Plate. Make sure
the Gutter Drip flashing is flush with the finish wall surface.
2. Temporarily fasten the Gutter Drip to the Eave Plate. Once panel installation occurs, permanent
fasteners will be placed through the panel into the Gutter Drip and the Eave Plate.
3. Apply a continuous strip of Double Bead Tape Sealant where the Gutter Drip rests on top of the
Eave Plate. Do not remove the paper backing off of the Double Bead Tape Sealant.
The Gutter Drip flashing provides additional protection against moisture at the eave end of
the roof and is used only in conjunction with the Snap-Loc Sculptured Gutter.
The Gutter Drip flashing can be installed either prior to or during roof panel installation.
It is recommended that the wall surface be installed prior to the Gutter Drip installation.
The following procedures also apply to applications utilizing Snap-Loc Sculptured Eave.