Metal Sales Snap-Loc 24 Installation - Manual (Page 19)

© Metal Sales Manufacturing Corporation / Subject to change without notice. 10/99
SNAP-LOC 24
18
DESIGN / INSTALLATION CONSIDERATIONS
(CONT.)
BEARING PLATE - Bearing Plate is used when installing panel directly over rigid insulation material.
The Bearing Plate (Flat) is used in conjunction with a 3
1 /
4
" Floating or Fixed Clip.
SNAP-LOC 24 PANEL
BEARING PLATE (FLAT)
DEKFAST
PANEL CLIP
LENGTH - Minimum factory cut length is 5'-0" on panels. Maximum recommended panel length is
45'-0". Longer panels require additional consideration in packaging, shipping, and erection. Please
consult Metal Sales for recommendations.
There are three critical measurements involving roof panels: the length of overhang required at the
eave, the offset at the peak end, and the position of the panel endlap (if required). In each case a certain
measurement is required. Check each measurement to ensure panel placement gives you the distance
required at the eave, peak and endlap condition (if required). In most cases any variance can be taken
out at the eave and peak.
PANEL
BEARING PLATE (FLAT)
SNAP-LOC 24 PANEL
WALL PANEL
PEAK END
EAVE END
SNAP-LOC SCULPTURED EAVE
3"
SNAP-LOC SCULPTURED GUTTER
3"
1'-0"
ENDLAP
2 1/8"
9 "
9 "
SSR HIGH SIDE PITCH BREAK
SSR RIDGE
ENDLAP PURLIN
BASED ON MAXIMUM SLOPE OF 4:12.
PANEL CLIP WITH BEARING PLATE (FLAT)
RIGID INSULATION
METAL DECK
6"