4 setting the mode for process data transfer, Setting the mode for process data transfer, Configuring system bus (can) – Lenze ECSCExxx Power supply module User Manual
Page 89
Configuring system bus (CAN)
Setting the mode for process data transfer
l
89
EDBCSXE040 EN 7.0
8.4
Setting the mode for process data transfer
The process data can be transmitted cyclically (sync−controlled,
^ 156) via CAN1_IN/OUT
or event−controlled/cyclically without sync (
The configuration is carried out via C0360.
Parameter
C0360
Designation
CAN PDOs/mode selection
Data type: INTEGER_32
Index: 24215
dec
= 5E97
hex
Selection of CAN PDOs/mode for the process data transfer via the system bus (CAN)
^ 89
Selection list
(Lenze setting printed in bold)
Information
0 No response
event−controlled/cyclic without sync
1 CAN1_IN/OUT
cyclic (sync−controlled)
This manual is related to the following products: