Lenze ECSCExxx Power supply module - Manual (Page 11)

Preface and general information
Properties of the ECSxE power supply module
1
l
11 EDBCSXE040 EN 7.0
1.3 Properties of the ECSxE power supply module
ƒ Generation of the DC−bus voltage for an ECS drive system or single drive
ƒ Controlled charging of the DC bus
ƒ Check of the DC bus for earth fault and short circuit during mains connection
ƒ Automatic detection of mains voltage
ƒ Mains failure monitoring
ƒ Single−phase mains current measurement for diagnostics
ƒ Internal brake chopper IGBT
ƒ Mains−voltage dependent adaptation of brake chopper switch−on voltage
ƒ Internal brake resistor with monitoring (not for ECSCE series in cold plate design)
ƒ Connection of external brake resistor with temperature switch possible
ƒ Integrated system bus interface (CAN) for transmitting process data, parameter
setting and diagnostics
ƒ EtherCAT connection to the EMF2192IB communication module via the automation
interface (AIF)
ƒ Commissioning, parameter setting and diagnostics with the Lenze parameter
setting and operating program "Global Drive Control" (GDC) or the XT EMZ9371BC
keypad