Lenze ECSCExxx Power supply module - Manual (Page 2)

l
2 EDBCSXE040 EN 7.0
,
Please read these instructions before you start working!
Follow the enclosed safety instructions.
This documentation is valid for the ECSxE power supply modules as of version:

ECS x E xxx x 4 x xxx XX xx xx
Device type
AT
TENTION
L
´appareil est sous tension
pendant 180s après la coupure de la tension réseau
W
ARNING
Device is live up to 180s after removing mains voltage

Design
E = standard panel−mounted unit, IP20
D = push−through technique (thermally separated)
C = cold−plate technique
Rated current
012 = 12 A
020 = 20 A
040 = 38.5 A
Fieldbus interface
C = system bus CAN
Voltage class
4 = 400 V/480 V
Technical version
B = standard
V = coated
Variant
Hardware version
VA or higher
Operating software version (B−SW)
1.2 or higher
0Fig. 0Tab. 0
© 2013 Lenze Drive Systems GmbH, Hans−Lenze−Straße 1, 31855 Aerzen
No part of this documentation may be reproduced or made accessible to third parties without written consent by Lenze Drive Sy-
stems GmbH.
All information given in this documentation has been selected carefully and complies with the hardware and software described.
Nevertheless, discrepancies cannot be ruled out. We do not take any responsibility or liability for any damage that may occur. Ne-
cessary corrections will be included in subsequent editions.