Lenze ECSCExxx Power supply module - Manual (Page 82)

Configuring system bus (CAN)
Setting the CAN node address and baud rate
Settings via DIP switch
8
l
82 EDBCSXE040 EN 7.0
8.1 Setting the CAN node address and baud rate
The CAN node address and baud rate can be set via the DIP switch (S1) or via C0350/C0351.
ƒ If one of the (address) switches 2 ... 7 of the DIP switch is switched on (ON) and the
low−voltage supply is connected, the setting of the DIP switch is evaluated and
entered into C0350 (CAN node address) and C0351 (baud rate).
ƒ If the (address) switches 2 ... 7 are switched off (OFF), the switch position is not
evaluated. The node address and the baud rate are then taken from C0350 and
C0351.
ƒ The switch 1 of the DIP switch has no function.
8.1.1 Settings via DIP switch
ECSEE_002B
Fig. 8−2 DIP switch for node address and baud rate (all switches: OFF)