Lenze ECSCExxx Power supply module - Manual (Page 81)

Configuring system bus (CAN) 8
l
81 EDBCSXE040 EN 7.0
8 Configuring system bus (CAN)
The drive system can be adapted to your application by configuring the power supply
module. These interfaces can be used to configure the power supply module:
ƒ X1 ˘ AIF (automation interface)
– For the connection of the keypad XT or communication modules (
^ 167) which
serves to access the codes.
ƒ X4 ˘ System bus interface (CAN)
– PC interface/HMI for parameter setting and diagnostics (e.g. with the Lenze
parameter setting and operating program "Global Drive Control")
or
– Interface to a decentralised I/O system
The codes for configuring the system bus (CAN) can be found in the GDC parameter menu
(
^ 75) under system bus (CAN).
X4
4 5
X4
X14
X4
X14
X4
X14
Systembus (CAN)
MotionBus (CAN)
Y Z
y
z T V
S U
d A B b c
p SHPRG
Para Code Menu 0050 00
50.00_Hz
M C T R L- N O U T
X1 X1
X4
X14
X1 X1
0 1 3
X1
2
ECSXA028
Fig. 8−1 Example: Wiring of the MotionBus (CAN) and system bus (CAN)
0
Keypad XT or another communication module
1 PC/laptop or HMI
2 Decentralised I/O system
3 Higher−level host system / MotionBus control
4 ECSxE... power supply module
5 ECSxS/P/M/A... axis module
I
Tip!
More detailed information on the CAN bus can be found in the appendix of
this documentation (
¶ 147).